Jaguar Seat Control Switch Repair 1995 XJ6

I had a problem with moving the seat back after my wife was driving my car. The seat switch would respond to every direction and control with the exception of moving the seat back.

Removed the switch and opened it with my pocketknife. 

Removed the removed the electrical control from the housing. 

Removed the rubber-molded contacts from the circuit board. 
 

Notice the wear marking in the contacts. 
 

Used an eraser and alcohol to clean both the circuit board and contacts. 
 

I put it together and it worked just fine. I do believe that if it begins to act up again I will sand the contacts lightly and try it again. 

 

Follow Gus_jagrepair on Twitter

You should follow JagRepair.com on Twitter

See us on Facebook
 

 

Please support JagRepair.com

 

 

Home | Contact Us!

JagRepair.com is designed as an information resource and is not a forum.

All information provided is believed to be correct and it is given in good faith. Users of this information will use good judgment and comply with all the safety rules that apply to operating tools and equipment. JagRepair.com cannot be held responsible if any of the information provided is not correct or does not work for you. Owner of the vehicle accepts responsibility with any and all applications they choose to use.

JAGUAR and its logo are the registered trademarks of Jaguar Land Rover Limited. Jaguar Land Rover Limited is not affiliated with JagRepair.com.

JagRepair.com © 2012 - 2017 by Gus Glikas. All rights reserved.
The JagRepair logos and all proprietary artwork, photos and content are the property of Gus Glikas and may not be reproduced or distributed without expressed written permission.