Jaguar Remote 1999 XK8

At times my remote would not work. Replacing batteries did not fix the problem so I elected to see if I could find the problem. What I found out is that it needed a little cleaning.

This is the remote LJA2610AA, 315mhz Batteries are CR2016 3V, 2ea

Notice the black marks on the circuit board. This is the locations for the buttons
 

Same photo just a little closer.
 

Used Rubbing Alcohol with a Q tip to remove the black residue from board
 

The cleaned board
 

After I put it back together I had to press the unlock button 2 to 3 times before the car would respond. After that it worked just fine.
 

 

Follow Gus_jagrepair on Twitter

You should follow JagRepair.com on Twitter

See us on Facebook

 

 

Please support JagRepair.com

 

 

Home | Contact Us!

JagRepair.com is designed as an information resource and is not a forum.

All information provided is believed to be correct and it is given in good faith. Users of this information will use good judgment and comply with all the safety rules that apply to operating tools and equipment. JagRepair.com cannot be held responsible if any of the information provided is not correct or does not work for you. Owner of the vehicle accepts responsibility with any and all applications they choose to use.

JAGUAR and its logo are the registered trademarks of Jaguar Land Rover Limited. Jaguar Land Rover Limited is not affiliated with JagRepair.com.

JagRepair.com © 2012 - 2017 by Gus Glikas. All rights reserved.
The JagRepair logos and all proprietary artwork, photos and content are the property of Gus Glikas and may not be reproduced or distributed without expressed written permission.